mvp_scott

Exhaust for spark?

110 posts in this topic

Wow look at this guys someone has added 6 exhaust tips to a spark!

Share this post


Link to post
Share on other sites

Holy..... Sounds great

Share this post


Link to post
Share on other sites

Yes but that will degrade your engine performance because you need some backpressure.

Share this post


Link to post
Share on other sites

The compression on these engines is about 9.3:1 back pressure isn't needed as much as people think. If you have a manual transmission it may not be noticeable at all really.

Share this post


Link to post
Share on other sites

Yes but 6 mufflers is just too much and it has only 4 cylinders 2 for each lol.

Share this post


Link to post
Share on other sites

Yes but 6 mufflers is just too much and it has only 4 cylinders 2 for each lol.

Share this post


Link to post
Share on other sites

With mine I just had a local exhaust shop make a custom set-up with 1.75" pipe, a Magnaflow muffler & chrome turn-down tip. Sounds really good & sure it helped the flow too!

post-963-0-63386300-1439172763_thumb.jpg

Dakota J Skidds likes this

Share this post


Link to post
Share on other sites

So I'm new to this whole forum thing and j know this thread has been dead for a long time but I figured I'd share what I came up with as a solution to the aftermarket exhaust. I recently built a cat back system that bolts right up to the secondary cat, removes the resonator, has an aftermarket chambered muffler to avoid losing too much back pressure, and I increased the pipe size from 1.5" to 1.75" only because it was easier to come by. It utilizes all factory hangers, has flanges in the factory locations(at the cat and above the rear axle), and is basically a direct bolt in with the exception of the tip(I'll get to that in a minute). I used a thrush welded muffler with a 2.25" inlet and outlet and it does not sound raspy in the slightest bit. It's actually pretty deep for the size motor. The tip also exits through the rear bumper like it does in the Chevy Beats that they sell over seas. It looks better in my opinion and it also helps with the interior resonation because the sound waves aren't getting trapped under the car. Let me know what you guys think. For the record, I know the welds aren't the best looking considering I used a flux cored welder and the fact that I'm an electrician and not a welder by trade. But there are not leaks so that's a plus.

Share this post


Link to post
Share on other sites

I have to first figure out how to upload pictures though

Share this post


Link to post
Share on other sites

20180219_114033_zps85egj6ux.jpg
20180219_124842_zps5jbktomo.jpg

LittleBlue! likes this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now