Search the Community
Showing results for tags 'manual'.
Found 3 results
Hey there fellow spark owners, I just got my first 2015 Chevy Spark LS which is also my first car, it's a certified pre-owned with 27k miles on it. So far it's been a blast driving and learning in! Looking forward to sharing and learning with everyone here!
And just when me and the Tomato had come to an understanding and where willing to live together Just dropped off the Spark (I.E. The Tomato) at the dealer today, they suspect bad wheel bearings. The dealer still does not know if its a front hub or rear wheel bearing. I just clocked 7000 miles on my 2013 Spark LS Manual, for wheel bearings to go bad this early is beyond absurd! I just got my first oil change and tire rotation at 6500 miles, after that, I kept my ears sharp for excessive wheel noise, just in case plausible bad alignment had caused abnormal wear on the front tires, which has been an issue on some 13's. I noticed an increasing hum that would start at around 40mph and would increment as vehicle speed increased. This hum would occur regardless of road surface type, asphalt or concrete. The hum is low in volume, and can be hidden by the usual tire noise and engine noises. The service advisor was perplexed that such a thing could happen this early in the car's life, and remarked this was the first Spark they had with this problem at Ron Craft Chevrolet. My advice to all who read this, listen for wheel bearing defects in earnest. Below are the things to listen for: 1. Increasing humming sound when accelerating to highway speeds regardless of road surface type 2. Decreasing humming when exiting a highway. 3. Humming that does not go away when changing gears or coasting. 4. Humming that is noticeable under a determinate speed range, for my car it was between 40 and 60mph. These cars are pre-equipped with cheap, noisy, Goodyear tires, but a bearing noise will be different from tire and wind noise. Tire noise will fluctuate depending on road surface quality, wheel bearing noise will not. A wheel bearing or hub bearing in good condition will make absolutely no noise or humming. If you have this situation in your Spark, do not hesitate and get it checked out at the dealer. Bad wheel and hub bearings are very dangerous, in the least, they will cause extra noise in an already noisy car, worst case scenario they can seize a wheel or even make a wheel snap off the hub. If you do have this situation and go get the car tested, try to make your test run on an asphalt road, preferably a freshly paved one, as it is a quieter surface for the tires and will make bearing noise really stand out.
Hi everyone, I drive a 2014 Spark, and I am interested in purchasing a dealership-level service manual so I can do maintenance the way GM intended. Purchasing a 2014 Spark manual costs $300, but getting a 2013 Spark manual is only $200. Why is that? Also, does it make a difference if I use a 2013 manual to service a 2014 vehicle? Surely there can't be many differences between vehicles one model year apart, right? The 2013 manual is located at: http://www.helminc.com/helm/product2.asp?Make=CHV&Model=SPAR&Year=2013 The 2014 manual is located at: http://www.helminc.com/helm/product2.asp?Make=CHV&Model=SPAR&Year=2014 Thanks for the assistance, Pat